1. Pour the crystal drop glue A and B into the beaker 2 and stir in the same direction for more than 2 minutes at the ratio of 1∶1(1 part of A glue and 1 part of glue). Don't act too rough, Stir well. After mixing 3. evenly, stand still for about 3 minutes and wait for defoaming. 4. pour into the mold or water on the finished product. ∶ of matters to be noted during use When 1) tune must pay attention to the proportion of accurate, B glue can be more, but must not be less, less will affect the curing time and hardness, and may not even solidify. 2) stirring must be uniform, especially the inner wall of the container, bottom, etc., stirring must be in place, time at least 60 seconds. Can use glass stick, disposable chopsticks, bamboo stick and so on. After mixing the 3) evenly, there will be bubbles in the process of mixing, so it can be set still for a while, and then automatically defoaming to the transparent state. 4) the use of crystal glue, be careful not to stick to the hands, body, if such a situation, can first use cloth or paper towels to wipe off the glue, and then wash with water soap detergent or alcohol, etc. ) This type of crystal glue is epoxy AB glue, if you need to drop the product with arc surface, need a bottom bracket or container with border, and after mixing the glue evenly, the thicker is re-use. If you need high-arc products, please select the mold mining operation completed. 6) pay attention to place the product desktop to keep level, and the bottom of the product must be cushioned with flat thick paper to prevent spills, pad thick paper, even if there is an accident, overflow out, will not stick to the table, so that it is difficult to clean. 7) just prepared glue is relatively thin, it is best to place the glue slightly sticky when used, the specific time depending on the local temperature at that time. 8) the configuration of the glue to be used up before thickening, how much need to match how much, so that will not waste. 9) drop good product must pay attention to dustproof, had better use cover to cover well, if the surface carelessly stick to dust, also want to use the tip to pick out drop glue best 3 months use up, B glue see light time long can make yellow oh. The cleaning ∶ of the container can be first wiped with paper towels, and then with acetone, alcohol, nail washing water (do not buy mild type without acetone), nail towel, soap, detergent, washing powder and other cleaning, it is important to note, please use hot water + detergent or hot water + washing powder such combination cleaning, do not use cold water. The glue drop solidification time is about 2.3 days.